VAKUR
English

Baby monitor app keeps disconnecting: causes and fixes

Last updated: October 31, 2026

When a baby monitor app keeps disconnecting, the cause is usually one of four things: the baby phone is not charging, power saving pauses the app, the Wi-Fi in the nursery is weak, or the app was swiped away on the parent phone. Most of these take a minute to fix. Just as important is that you hear it when the connection drops.

First: make sure you notice when it drops

No connection between two devices is perfect. Routers restart, phones switch networks, batteries run down. The dangerous situation is not a short drop but a silent one, where the parent phone looks normal and nothing is coming through.

Vakur sounds a loud alarm on the parent phone when the connection is lost, even with the screen locked. It warns you beforehand if the volume is set too low, keeps trying to reconnect and stops the alarm when the connection is back.

Cause 1: the baby phone runs out of power

Live video for a whole night drains any battery. If the baby phone is not on the charger, it will switch off sooner or later. Plug it in every time and check that the cable is firmly seated. Use a charger you trust, and keep the cable out of your baby’s reach.

If the phone is old and its battery weak, switch to sound-only mode, which saves battery.

Cause 2: power saving pauses the app

Many phones, especially Android phones, pause apps in the background to save energy. A baby monitor app that gets paused stops sending. Turn off battery saver on both phones while you use the monitor and, if your phone offers it, allow the app to run without battery restrictions.

On the baby phone, leave Vakur open in the foreground. The screen dims by itself, so it does not need to stay bright.

Cause 3: weak Wi-Fi in the nursery

Nurseries are often at the end of a corridor or on another floor, where the Wi-Fi is weakest. Walk into the room with a phone and look at the signal. If it is low, move the phone a little, move the router, or add a mesh point or repeater.

Remember that Vakur also works on mobile data and on different networks, so a baby phone on mobile data and a parent phone on Wi-Fi is a valid setup.

Cause 4: the app was swiped away on the parent phone

Many people swipe away their open apps before going to sleep. If you do that with the baby monitor app on the parent phone, it can no longer play sound or raise an alarm. You can lock the parent phone, but leave Vakur open in the background.

A quick checklist

Go through these steps once, then test the setup: put the baby phone into airplane mode and leave it there for about half a minute. The parent phone should sound the alarm. Switch airplane mode off again, and the alarm stops once the connection is back.

When the alarm sounds

Check that the baby phone is switched on, has power and is online. Vakur keeps trying and reconnects by itself as soon as it can. If it keeps happening at the same time each night, look for a pattern: a router that restarts overnight, a guest network that logs devices out, or a power-saving schedule on the phone.

Common questions

Why does my baby monitor keep cutting out?

Usually because of power saving, a phone that is not charging, weak Wi-Fi in the nursery, or a closed app on the parent phone. Check each in turn.

Will I know if the baby monitor app disconnects?

With Vakur, yes. The parent phone sounds a loud alarm when the connection is lost, even when it is locked.

Try Vakur on your own phones

Two phones, iPhone or Android in any combination. The parent phone is always free, the baby phone is free for 48 hours, then one single purchase – no subscription.

App StoreGoogle Play

More guides